serv-Clip Type 1
Pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes)
Pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes) with 1/4" screw
For hydraulic and gear oils
Installation of Sensors in few minutes - no cutting pipelines - Installation with jaw/screw wrench only
How it works?
A needle is pressed through the wall of the pipe. It uses the principle of plastic deformation to create a leak-proof opening.
Hydraulic pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes)
This is what you can do instantaneously:
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters
Quick and cheap installation (only 3 minutes)
Measurement without switching off
No need to cut tubes
No cleaning necessary
No contamination of fluids
For installation on steel and (*)stainless steel pipes
from 10 - 42 mm /Tube 3/8" - 2" / Pipe ¼" to 3"
Working pressure up to 630 bar (9100 psi)
Working temperature from -40°C to +120 °C
Viton O-Ring in leak proof clamp (200°C) incl 1/4"screw and valve M16x2
(*)Up to 5 mm with special needle Art.Nr.501-040-02 possible.